Step 1. Connect Device

MOVIN’s hardware, Tracin, and software, Studio, communicate via an Ethernet cable.

Follow the steps below to establish a seamless connection between the two devices.

1. Power On Tracin

This is the first step of 1. Connect Device in Studio.

There are two ports on the underside of Tracin—a rectangular Ethernet cable and a circular power port.

• There are two ports on the underside of Tracin—one for the Ethernet cable and one for power. Connect the round power port to the power adapter jack and plug it into an electrical outlet.

• Once connected, wait 1 to 1.5 minutes. The front LED on Tracin should turn green.

  • If the LED doesn’t light up or blinks, unplug the power jack and reconnect it.

For persistent issues, contact MOVIN via the Discord server’s cs-chat channel. We'll assist promptly.

2. Connect Tracin to Your PC with an Ethernet Cable

This is the second step of 1. Connect Device in Studio.

• Connect the Ethernet cable to Tracin’s Ethernet port and your PC’s Ethernet port.

• If the Ethernet cable is already connected, unplug it and reconnect to ensure a stable link.

3. Configure Your PC’s Network Settings

This is the third step of 1. Connect Device in Studio.

1. Open Windows Search and type “View Network Connections” to access the network settings

   • Alternatively, navigate to: Control Panel > Network and Internet > Network and Sharing Center > Change Adapter Settings

   

   Search and navigate to 'View Network Connections'.
2. Right-click the Ethernet or Local Area Connection icon and select Properties.

   

   Right-click the 'Ethernet' icon and select 'Properties'.
3. Double-click “Internet Protocol Version 4 (TCP/IPv4)”.

   

   Select 'Internet Protocol Version 4 (TCP/IPv4)'.
4. Select “Use the following IP address” and enter the following details, and click OK to save:

   • IP Address: 192.168.2.77

   • Subnet Mask: 255.255.255.0

   

   Set IP address and subnet mask manually.

• This configuration is saved and doesn’t need to be repeated. If you need to use the Ethernet port for internet later, return to Step 4 and select “Obtain an IP address automatically.”

4. Verify the Connection

This is the fourth step of 1. Connect Device in Studio.

• Open Studio and click the “Verify Connection” button in the center of the interface.

  • If successful, a message saying “Device setup for TRACIN is complete.” will appear, and the “Device Connection” icon in the top-right corner will turn green.

• Close the connection modal by clicking “Device Connected” or the X button in the top-right corner.

• If the connection fails:

  1. Ensure Tracin’s front LED is not:

     • Turned-on: Power is not properly supplied. Unplug the power jack and reconnect.

     • Blinking: There may be an Ethernet cable issue. Unplug the ethernet and reconnect.

  2. Open an internet browser and go to 192.168.2.100:8000.

     • Click the button at the center to check two products are connected.

If the issue persists, contact us via MOVIN’s cs-chat channel on Discord, and we’ll resolve it as quickly as possible.