Setup overview
The workspace has three stages, walked in order from the left navigation. You set up in the first two — Calibration and Settings — then watch the broadcast in Live. Each stage unlocks the next when it is complete; you cannot open a locked stage.
Before you start
Have the following ready:
All sensors mounted around the stage — see Mounting the sensors.
All sensors powered on, connected, and PTP-synced.
The calibration wand (Regular or Big) within reach.
Clear walking access to the whole stage.
Your OSC target — the IP address and port of your lighting console, VJ application, or game engine.
The three stages
Calibration — connect the sensors and align them into one shared 3D scene using the calibration wizard. This is required once per installation, or after a sensor is moved.
Settings — set the tracking zones, configure post-processing, and specify the OSC destination. Entering this stage starts the pipeline in preview mode (off-air), so you can configure everything while viewing live sensor data.
Live — broadcasting is active; monitor the show. See Running a show.
Each stage's guide card points at the next required step with a Next button. If a valid calibration from a previous show is already loaded, select Skip to Settings › on the Calibration guide card.
Calibration locks once the pipeline is running. Entering Settings starts the pipeline, which commits the calibration. The calibration cannot be changed while the pipeline runs. To change it, select the locked Calibration stage (🔒) and confirm that you want to stop the pipeline.
Last updated